小型
自動混凝土攪拌機在使用的時候會(huì )出現噪音,是什么樣的原因能夠使車輛出現噪音呢?我們應該如何進行處理呢?
Small automatic concrete mixer will make noise when it is used. What kind of reasons can make the vehicle make noise? How should we deal with it?
1、罐體內有粘結的混凝土存料:要清鏟干凈。
1. Bonded concrete storage in the tank: clean it.
2、吸油管路進氣或堵塞:檢查擰緊,不要吸進空氣。
2. Air intake or blockage of oil suction pipeline: check and tighten, do not suck in air.
3、泵的安裝支架的剛性不足,工作時會(huì )產生震動和噪音:加固支架。
3. The rigidity of the mounting bracket of the pump is insufficient, which will produce vibration and noise when working: reinforce the bracket.
4、工作油液不合要求或油液粘度太大:更換低粘度的液壓油。
4. The working oil is not up to the requirements or the oil viscosity is too high: change the low viscosity hydraulic oil.
5、濾芯堵塞造成吸油困難或不足:清洗或更換濾芯。
5. Difficult or insufficient oil absorption due to blockage of filter element: clean or replace the filter element.
6、油箱液面太低,油面上空氣被吸入泵內:補加相同標號的液壓油。
6. The liquid level of the oil tank is too low, and the air on the oil surface is sucked into the pump: add hydraulic oil of the same label.
7、輸入法蘭與萬向傳動軸的連接、萬向傳動軸與取力器的連接角度過大、松動時會(huì )產生噪音:檢查緊固。
7. The connection between input flange and Cardan drive shaft, and the connection angle between Cardan drive shaft and power take-off are too large and loose, which will produce noise: check the fastening.
The working environment of small automatic concrete mixer is very bad, so it is inevitable that there will be some problems when it is used. Today, we explain the causes of noise and solutions, so that if you encounter problems, you can solve them. If you want more information, please follow our website: http://www.bosplumbing.com .