很多客戶買了我們的自上料攪拌車,用過一段時間后,都反饋會(huì )出現高噪音情況,甚懷疑是質量問題,這鍋我們可不背,今天小編就統一解答這一疑惑!
Many customers bought our self loading mixer truck. After using it for a period of time, they reported that there would be high noise and even suspected that it was a quality problem. We don't need to carry this pot. Today, Xiaobian will uniformly answer this doubt!
自上料混凝土攪拌罐車的高噪聲原因
Causes of high noise of self loading concrete mixing tank truck
1洗車水箱中的水量不足以清掉。向洗車水箱注滿水。
1. The amount of water in the car washing water tank is not enough to be removed. Fill the car wash water tank with water.
2如果吸管的進氣口堵塞或堵塞,可以檢查并擰緊吸管。不要進空氣。
2 if the air inlet of the straw is blocked or blocked, check and tighten the straw. Don't breathe air.
3自上料混凝土攪拌罐車油箱液位過低,并且油液中的空氣被吸入泵中。如果發生這種情況,您可以添加帶有相同標簽的液壓油。
3. The liquid level in the oil tank of the self loading concrete mixing tank truck is too low, and the air in the oil is sucked into the pump. If this happens, you can add hydraulic oil with the same label.
4如果泵的安裝支架不夠牢固,則在工作期間會(huì )產生振動和噪音。在這種情況下,可以加固油泵支架。
4 if the mounting bracket of the pump is not firm enough, vibration and noise will be generated during operation. In this case, the oil pump support can be reinforced.
5堵塞的濾芯會(huì )使吸油困難或不充分。在這種情況下,請清潔濾芯或更換濾芯。
5 blocked filter element will make oil absorption difficult or insufficient. In this case, clean the filter element or replace the filter element.
6冷卻風扇未打開。卸下:打開冷卻風扇。
6 the cooling fan is not turned on. Remove: turn on the cooling fan.
7如果液壓油不符合要求或油太粘,請更換符合標簽要求的低粘度液壓油。
7 if the hydraulic oil does not meet the requirements or the oil is too viscous, please replace the low viscosity hydraulic oil that meets the label requirements.
8自上料混凝土攪拌罐車儲罐中有堅硬的混凝土。如果發生這種情況,請及時清理并鏟除。
8. There is hard concrete in the storage tank of the concrete mixer truck. If this happens, please clean up and eradicate it in time.
9萬向傳動軸之間的連接角度以及傳動軸與取力器之間的連接角度太大,如果松開會(huì )產生噪音,在這種情況下,請在時間內檢查并擰緊。
9 the connection angle between the universal drive shaft and the connection angle between the drive shaft and the power take-off is too large. If it is loosened, it will produce noise. In this case, please check and tighten it within a time.
The wonderful content of this article is provided by the knowledge of automatic concrete mixer. There are many wonderful contents on this website. You can click to enter more contents: http://www.sdcgy.com We have special customer service to answer your questions