混凝土攪拌機是運輸混凝土的專用工具?;炷習?huì )腐蝕鋼和油漆。在運輸過程中,混凝土將在短時間內固化成硬塊。因此,每次運輸混凝土后,都需要仔細清洗并粘附。保持混凝土在混凝土罐中以及混凝土攪拌罐和車輛進出口的清潔,以使混凝土攪拌車的使用壽命更長,減少不必要的經濟損失,并為您帶來更多的財富和收入。
Concrete mixer is a special tool for transporting concrete. Concrete corrodes steel and paint. During transportation, the concrete will solidify into hard blocks in a short time. Therefore, after each transportation of concrete, it needs to be carefully cleaned and adhered. Keep the concrete in the concrete tank and the import and export of concrete mixing tank and vehicle clean, so as to prolong the service life of concrete mixing vehicle, reduce unnecessary economic losses, and bring you more wealth and income.
那么如何清洗混凝土攪拌車的水箱,下面介紹每次混凝土加載前后的操作步驟,希望對您有所幫助。
Then how to clean the water tank of the concrete mixer? The following describes the operation steps before and after each concrete loading, hoping to help you.
裝載后,用清水沖洗入口,以清潔入口附近的剩余混凝土,以防止運輸后干燥后混凝土吸附在入口上。干燥的混凝土不易清洗。每次運輸混凝土時,都要用水沖洗進料口,以保持裝載的混凝土入口濕潤。在施工現場卸貨后,及時用自帶的清洗水沖洗卸料斜槽,然后向混凝土儲罐中添加一些清潔水,以保證車輛返回時混凝土儲罐緩慢轉動。及時將水箱中的混凝土殘渣干燥,以防止混凝土吸附在水箱內壁上。當它到達攪拌站并重新裝填混凝土時,要排掉水箱中的清潔水,然后重復相同的步驟。在將混凝土運輸到罐體和進料口時避免混凝土吸附;裝載混凝土時,請勿懶散,并用清洗水填充車輛隨附的清洗水箱,并始終注意清洗水箱的水位,以免在清洗或進水時沒有水;
After loading, wash the inlet with clean water to clean the remaining concrete near the inlet to prevent the concrete from adsorbing on the inlet after drying after transportation. Dry concrete is not easy to clean. Each time the concrete is transported, the feed inlet shall be flushed with water to keep the loaded concrete inlet wet. After unloading at the construction site, wash the discharge chute with its own cleaning water in time, and then add some clean water to the concrete storage tank to ensure that the concrete storage tank rotates slowly when the vehicle returns. The concrete residue in the water tank shall be dried in time to prevent the concrete from being adsorbed on the inner wall of the water tank. When it reaches the mixing plant and refills the concrete, first drain the clean water from the water tank, and then repeat the same steps. Avoid concrete adsorption when transporting concrete to tank and feed inlet; When loading concrete, do not be lazy, fill the cleaning water tank attached to the vehicle with cleaning water, and always pay attention to the water level of the cleaning water tank to avoid no water during cleaning or water inflow;
在工作時,需要仔細清潔油箱本體,進料口,卸料斜槽以及所有輪胎粘附在混凝土上的地方,以確保車輛的整體清潔。采取一些步驟,使您的財富工具持續更長的時間。帶給您更多的財富。
During operation, it is necessary to carefully clean the fuel tank body, feed inlet, discharge chute and all places where the tires adhere to the concrete to ensure the overall cleanliness of the vehicle. Take some steps to make your wealth tools last longer. Bring you more wealth.