自動上料混凝土攪拌車密封膠條的日常維護!_公司新聞_自動混凝土攪拌機知識_自動混凝土攪拌機_自動混凝土攪拌車廠家

站內搜索

自動混凝土攪拌機知識

公司新聞行業資訊

熱點

自動上料攪拌車的四大功能

2022-05-18

夏季如何防止混凝土攪拌車全自動攪拌車過熱？

2021-06-15

降低自動攪拌車零件磨損需注意的問題！

2021-02-06

攪拌機一體機的倒車誤區有哪些？

2022-09-02

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

自動上料混凝土攪拌車密封膠條的日常維護!

所屬分類：公司新聞發布時間：2020-10-08 來源：http://www.bosplumbing.com/ 瀏覽量：0

1、檢查混凝土攪拌車密封條有無大的裂紋，有無斷裂。如果密封條斷裂了，可以使用粘結劑進行修補。特別是使用密封條專用粘結劑，很容易就能把大的裂紋條補好。當然，如果密封條損傷嚴重，或老化程度較大，還是更換新密封條省事。

1. Check whether the sealing strip of concrete mixer truck has large cracks and cracks. If the seal is broken, it can be repaired with adhesive. Especially using special adhesive for sealing strip, it is easy to mend the big crack strip. Of course, if the seal is seriously damaged or aged, it is better to replace the new seal.

2、司機在使用混凝土攪拌車洗滌劑進行清洗門窗密封膠條之后，涂覆一層高滲透性的保護劑，這樣既能防止密封條老化又能極大地提高密封條的密封性。除此之外，密封條的縫隙之間很容易塞滿沙塵，從而引發銹蝕。為此，應該用刷子把沙塵等干凈。

2. After cleaning the sealant strip of doors and windows with concrete mixer detergent, it is better to apply a layer of protective agent with high permeability, which can not only prevent the sealing strip from aging, but also greatly improve the sealing performance of the sealing strip. In addition, the gap between the sealing strip is easy to be filled with sand and dust, causing corrosion. Therefore, the dust should be removed with a brush.
自動混凝土攪拌車

3、在更換整個車身時，應在焊縫的搭接部分涂一層密封膠，膠層厚度應約為1mm，并且膠層不得有虛粘、氣泡等缺陷。在整個地板下表面和前輪罩下表面應涂3mm-4mm的彈性涂層及防腐涂層。這些措施不僅可以大大增強整車的密封性和減慢車身的銹蝕速度，而且還可以大大提高乘坐舒適性。

3. When replacing the whole car body, a layer of sealant should be applied to the lap joint of the welding seam. The thickness of the adhesive layer should be about 1 mm, and the adhesive layer should not have defects such as virtual adhesion and bubbles. 3 MM-4 mm elastic coating and anti-corrosion coating shall be applied on the whole underfloor surface and the lower surface of front wheel housing. These measures can not only greatly enhance the sealing of the vehicle and slow down the corrosion speed of the body, but also greatly improve the riding comfort.

4、車門與車身的密封是一個比較困難的部位，密封要求比較嚴，應密封的部分比較長，各密封部位的斷面形狀不盡相同，而且車門啟閉頻繁。在混凝土攪拌車上常設置3道,4道密封，安裝前支柱及車頂側橫梁部位的四重密封的構造。這種多道密封一般都布置在前門縫里，除具有密封功能外，還有汽車隔音降噪的作用。

4. The sealing between the door and the body is a difficult part. The sealing requirements are relatively strict. The parts that should be sealed are relatively long. The section shape of each sealing part is not the same, and the door is opened and closed frequently. In the concrete mixer truck, three or four seals are often set up, and the four seal structure of the front pillar and roof side beam is installed. This kind of multi-channel seal is generally arranged in the front door seam. In addition to the sealing function, it also has the function of sound insulation and noise reduction.

5、在車窗玻璃損壞后，司機在換用玻璃時，要檢查密封條有無損傷。由于車窗經過修理后往往回復不到原來的形狀，因此，這時除了要保證能輕松拉動或升降車窗玻璃外，還要注意車窗玻璃四周的密封性。如果玻璃同玻璃槽口的縫隙不均，橡膠條與玻璃、玻璃槽接觸不良，司機可以用手能輕易地將密封條拉脫。

5. After the window glass is damaged, the driver should check whether the sealing strip is damaged when changing the glass. As the window after repair often can not return to the original shape, so at this time, in addition to ensuring easy pulling or lifting the window glass, but also pay attention to the sealing around the window glass. If the gap between the glass and the glass slot is uneven, and the rubber strip is not in good contact with the glass and glass groove, the driver can easily pull off the sealing strip by hand.

6、司機在換車頂時，應先在車頂周邊壓合處涂一層導電密封膠，待焊好后再在流水槽內及接縫處遍涂折邊膠，這不但有助于車身的密封，更可防止車身因翻邊焊縫處積水而產生早期銹蝕。

6. When changing the roof, the driver should first apply a layer of conductive sealant at the pressing joint around the roof, and then apply the folding adhesive in the water channel and the joint after welding. This not only helps to seal the body, but also prevents the body from early corrosion due to water accumulation at the flanging weld.

7、混凝土攪拌車天窗是大多數家用轎車的基本配置。當汽車天窗打開時，橡膠密封條軌道暴露在空氣中，難免堆積粉塵，甚跑進小沙礫。長時間使用可能導致天窗因磨損而變形，并堵塞排水孔。所以定期清理軌道，為軌道涂抹潤滑油十分重要。

7. The skylight of concrete mixer truck is the basic configuration of most family cars. When the car skylight is opened, the rubber sealing strip track is exposed to the air, which inevitably accumulates dust and even runs into small gravel. Prolonged use may cause the skylight to deform due to wear and block the drain hole. Therefore, it is very important to clean the track regularly and apply lubricating oil to the track.

有了自動混凝土攪拌車上面的小總結，希望對廣大客戶有所幫助，如果有什么不理解的或者尋求幫助的請點擊我們的網站：http://www.bosplumbing.com或者來電咨詢，我們會(huì )盡全力為您

With the summary of the automatic concrete mixer, I hope it can help our customers. If you have any questions or ask for help, please click our website: http://www.bosplumbing.com Or call consultation, we will try our best to solve it for you

上一頁：混凝土攪拌車每日使用檢查下一頁：正確操作混凝土攪拌車這些情況要熟知！

熱門產品 / HOT PRODUCT